Hughes AN6-098P User Manual download pdf (Page 47)

Chapter 3 • Assembling the antenna

1037312-0001 Revision A

Tightening the hardware

Tighten the hardware as follows:

1. Tighten the three nuts on the reflector rim (indicated by the

black arrows in

Figure 21).

2. Tighten the nut where the feed rods attach to the feed support

tube (indicated by the white arrow in

Figure 21).

The antenna is now assembled, as shown in Figure 22, and ready

for installation of the radio assembly.

• If you are installing a J-type radio, go to Chapter 4 –

Installing a J-type radio assembly, on page 31.

• If you are installing a cradle-type radio, go to Chapter 5 –

Installing a cradle-type radio assembly, on page 43.

Figure 21: Tightening nuts on feed rods and feed support tube

Figure 22: Completed antenna assembly (without radio)

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 93 94

No comments

Hughes AN6-098P User Manual Page 47