Hughes AN6-098P User Manual download pdf (Page 76)

Chapter 7 • Pointing the antenna

1037312-0001 Revision A

Installing the OPI

To prepare for antenna pointing, attach the OPI to the receive

cable from the LNB, as shown in

Figure 46. Note that the OPI

will not work unless it is enabled on the appropriate screen on the

installation software. (Check the box labeled

Enable OPI

Display

.) For further details, see Outdoor Pointing Interface

Operating Instructions (1031832-0001).

OPI block If you use an OPI with a model J-type radio assembly, you must

use a block (or filter). For details, including the specific block you

should use, see the Hughes Field Service Bulletin (FSB),

Standard OPI Configuration (FSB_060915_01A).

Install the block between the OPI and the radio as illustrated in

Figure 46. If the block you use has two female F connectors (at

both ends), you will have to make a jumper cable to connect to

the OPI.

Figure 46: OPI

T0172001

HughesNet

Block

(if required)

OPI

IDU

LNB

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 93 94

No comments

Hughes AN6-098P User Manual Page 76